Ignition System Operations - Weber 300 Guia Del Propietario

Q300

IGNITION SYSTEM OPERATIONS

If the ignition system fails to ignite the burners, then check the igniter.
• Check that both ignition wires are attached properly to igniter electrodes(1).
• Check that the ignition button pushes in, and returns to the out position.
If the ignition system still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site. Log
®
onto www.weber.com .
Q320
IGNITION SYSTEM OPERATIONS
If the electronic ignition system fails to ignite the outside burner, light the outside
burner with a match. If the outside burner lights with a match, then check the
Electronic Ignition System.
• Check that both of the ignition wires are attached properly to the igniter
electrodes(1) on the ignition module.
• Check that the Electronic Ignition Button is working by listening and looking
for sparks at the outside burner.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer
Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
MAINTENANCE
® .
(1)
29
(1)