Preparation - Truper PIPI-44E Manual Del Usuario

Preparation

To gain in good results the coating job it is important to prepare the surface to be sprayed. Before applying, thin the paint or
product to get the right viscosity.
Double-check the surface to be spayed is free of dust, dirt or grease. Mask the areas that are not to be sprayed with good
quality masking tape. The paint or product to be spayed shall be totally mixed and free of lumps or other particles. Many
substances can be sprayed with the paint sprayer. Read the manufacturer recommendations before buying the product.
Thinning the material
• Most paints are sold ready to apply with a brush, but thinning
is needed to be adequate for paint spaying. Follow the
product manufacturer indications to thin the product correctly.
• Add thinner from 5% to 10% until reaching the right viscosity
to apply the material.
• The viscosity cup included helps to determine the paint right
viscosity.
Viscosity is determined with the seconds the material takes to
be discharged from the viscosity cup. The next table shows the
recommended times for the different types of product.
Product
Water based paint
Primer
Varnish
Oil based paint
Enamel paint
Aluminum paint
Automotive sealant
Wood sealant
Wood preserver
Wood stain
• If after thinning the product the dispersion capacity is too low,
add more thinner. Slowly add more thinner from 5% to 10%
until the dispersion capacity meets your needs.
Filling up the container
• Disconnect the sprayer when filling up the
CAUTION
container with paint or product.
• Unscrew the sprayer container.
• Align the suction pipe depending the job to be carried out:
To spray horizontal objects set the suction pipe forward (A).
To spray objects above head set the suction pipe backwards (B).
• Set the container onto a piece of paper. Pour the prepared
coating and fasten the container in the sprayer.
Sconds to be discharged
20 - 35
24 - 35
20 - 30
18 - 30
18 - 30
22 - 30
25 - 40
28 - 40
No thinner required
No thinner required
Hose and carrying belt connection
• Fix the carrying belt in the base.
• Insert firmly the hose ends into the sprayer and air
pump.
00:20
J
B
A
7