Start Up - Truper PIPI-44E Manual Del Usuario

Pistola eléctrica para pintar
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Spray selector
• Before starting the paint sprayer adjust the type of spray suitable for the job.
• Loosen slightly the spray lock (A) so that the spray disperser (B) is released.
• Turn the disperser into the position most suitable for the job.
• Adjust back the spray lock.
A
Horizontal fan
Material volume selector
• Turn the volume selector (C) upward to increase the
volume of the spraying material.
• Turn the volume selector downwards to decrease the
spraying material.
D
Spraying techniques
• To gain good results always keep the sprayer level and parallel to the surface (E). Keep the nozzle at 10" - 12" from the
surface and spray evenly from side to side and up and down. Do not spray in an angle otherwise the paint will run on the
surface. Work with light and even passes. When spraying large surfaces use a crossed pattern (F).
• Never start or stop the sprayer while aiming at the surface to be sprayed.
• Move the sprayer with in a constant and uniform speed. Fast movements produce thin layers. Slow movements produce
thick layers.
• Apply one layer at a time. Before applying second layer read the drying recommendation of the product manufacturer.
Remember, to get a better finish it is better to apply two thin layers than only one thick layer.
• When spraying small areas keep the outlet control down. It prevents from using too much paint ant prevents from over
doing the spraying.
• Prevent when possible stopping and continuing the spraying of an object. It causes too much or very little paint.
• Do not tilt the paint sprayer in an angle higher than 45°.
E
8
ENGLISH
B
Circular
C

Start up

Vertical fan
Turning on
• Plug the cable into the power outlet.
• Press the switch on the air pump
• Press the trigger switch flow (D) to start the paint sprayer
motor and the product starts flowing out. Aim the sprayer
at a piece of cardboard until the product is sprayed.
• Release the trigger to stop the spray flow.
WARNING
• Never press the trigger while
adjusting the spray selector.
F

Hide quick links:

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

15383

Tabla de contenido