Safety Warnings For Power Sprayers - Truper PIPI-44E Manual Del Usuario

Safety warnings for
power sprayers
Substances and materials
CAUTION • The device is designed to apply coating
materials like paint, varnish, enamel, etc. These materials
shall have a flashpoint not lower than 70 °F.
WARNING • Do not spray substances you are not
familiar with and the potential hazard is unknown.
WARNING • Do not spray flammable substances.
Use care with hazards originated by the substances
sprayed. Review the text and information in the cans and
containers, or the manufacturer specifications.
Suitable materials
• Water solvent based paint, finish, primer, and paint with two
components, transparent finish, automotive finish, sealer, and
wood sealer.
Non suitable materials
• Wall paint (emulsion), alkaline or acidic paint.
Coating with a flashpoint lower to 70 °F
Before operating the device
• The device shall not be used in
CAUTION
enclosed spaces or explosive environments.
• When working outside consider the wind direction. Wind
can carry the coating long distances and cause damage
and make the job difficult.
CAUTION • When working indoors verify there is
adequate ventilation.
WARNING • The work area shall be free if ignition
sources. Do not smoke while spraying or near the work
place.
CAUTION • Use a breathing mask and safety glasses
when spraying to prevent damaging your lungs and eyes.
• Use hearing protection.
CAUTION
• People with medical implants. Before
using the sprayer is recommended to visit their physician
and consult with the implant manufacturer. The
electro-magnetic field produced could interfere with the
medical implant function.
While operating the device
CAUTION • Never point the sprayer towards your
body, passersby or animals.
• Make sure that the equipment does not absorb any
steam solvent.
CAUTION • In the event you need to pause during
the application process, do not set the sprayer sideways.
Set it onto the container base to keep the device in a
vertical position.
• Disconnect the sprayer from the power source when
filling up with paint or other product.
• Keep in mind the long exposure to vibration produced
by tools may be harmful. Remember, a tool in good
repair vibrates much less than a tool in disrepair.
After operating the device
WARNING
• Do not use solvents with a flashpoint
lower than 70 °F to clean the sprayer.
WARNING • Never open the device to carry out
repairs in the electric system.
ENGLISH 5