Important Safety Instructions - Franklin Electric S Serie Manual Del Usuario

Before Installation be sure to read all the instructions and
warnings carefully. Refer to the product data plates for additional
operating instructions and specifications.
INSPECTION
Examine the equipment when received. Notify your dealer or carrier of
any damage or missing parts. Verify that the equipment is of size and
model specified.
READ AND FOLLOW
SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
WA R N I N G
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
Wire motor for correct voltage. See "Electrical" section of
this manual and motor nameplate.
Ground motor before connecting to power supply.
Meets National Electrical Code, Canadian Electrical Code,
and local codes for all wiring.
Follow wiring instructions in this manual when connecting
motor to power lines.
D A N G E R
warns about hazards
that will cause serious personal
injury, death or major property
damage if ignored.
W A R N I N G
warns about hazards
that can cause serious personal injury,
death or major property damage
if ignored.
C A U T I O N
warns about hazards
that will or can cause minor personal
injury or major property damage if ignored.
The label NOTICE indicates special
instructions, which are important but
not related to hazards.
Carefully read and follow all safety
instructions in this manual and
on pump.
IMPORTANT SAFETY
INSTRUCTIONS
When installing and using this electrical equipment, basic safety
precautions should always be followed, including the following:
READ AND FOLLOW
ALL INSTRUCTIONS
W A R N I N G
This equipment must not be used by children or
persons with reduced physical, sensory or mental abilities, or lacking
in experience and expertise, unless supervised or instructed. Children
may not use the equipment, nor may they play with the unit or in the
immediate vicinity.
W A R N I N G
If power cord suffers damages, consider this
product does not allow partial replacement and therefore should
be fully replaced.
W A R N I N G
Risk of electric shock. Connect only to a branch
circuit protected by a ground fault circuit interrupter (GFCI). Contact
a qualified electrician if you cannot verify that the circuit is protected
by a GFCI.
The unit must be connected only to a supply circuit that is protected
by a ground fault circuit interrupter (GFCI). Such a GFCI should be
provided by the installer and should be tested on a routine basis. To
test the GFCI, push the test button. The GFCI should interrupt power.
Push the reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI interrupts
power to the pump without the test button being pushed, a ground
current is flowing, indicating the possibility of an electric shock. Do not
use the pump. Disconnect the pump and have the problem corrected
by a qualified service representative before using.
C A U T I O N
This pump is for use with permanently installed pools
and may also be used with hot tubs and spas if so marked. Do not
use with storable pools. A permanently installed pool is constructed
in or on the ground or in a building such that it cannot be readily
disassembled for storage. A storable pool is constructed so that it is
capable of being readily disassembled for storage and reassembled to
its original integrity.
W A R N I N G
Do not install within an outer enclosure or beneath
the skirt of a hot tub or spa.