LiftMaster ART200K Manual Del Usario página 24

FLASHING LAMP (OPTIONAL)
A flashing lamp can be connected to the control board. It warns
when the gate is being moved. The flashing light should be fitted as
high as possible and in good clear view. The control board emits a
constant signal that the lamp converts to a flashing signal.
Cable cross-section: 0.5 mm
Voltage: 24 V DC
RADIO
There are two small cartons. One of the cartons contains the receiver,
which stores remote control codes. The other one contains the radio
module, which receives the radio signal.
1. connect the smaller radio module with the receiver
Make sure all pins are properly engaged
2. connect the receiver with the control board
Antenna: The receiver includes a short antenna. It should
not come in contact with any cable and should not be rolled
up. It is possible to install an external antenna which
enlarges the operating distance of the remote control
(optional accessory).
PROGRAM / DELETE REMOTE CONTROLS
The receiver has two channels CH1 and CH2. Using the different
channels enables the opening of one wing resp. both wings. For
example, if CH1 receives the code from the remote control only one
wing will open. Choosing a different button on the remote control in
combination with CH2 will cause both wings to open.
In order to store a code press a previously selected button on the
remote control while simultaneously pressing the learn-buttons CH1
or CH2 of the receiver. Repeat for all remote controls.
A maximum of 12 remote controls can be programmed to each
channel.
Note: Make sure not to pogramm the same remote button to CH1
and CH2, otherwise the gate may work improperly. Redo
programming if required.
DELETE
Press learn-buttons (CH1 or CH2) for approx. 10 seconds until LED
goes out. All codes programmed to this channel are deleted.
JUMPERS
1 / 2 Motor
1 or 2 motors are connected to the control board.
FREE: both motors connected
LINKED: only one motor connected
STOP / 8.2 KOhms
Defines if connector STOP / 8.2 KOhms is used for an emergency
stop switch or for a safety edge. The emergency stop switch stops
any movement of the system immediately. The safety edge causes
the wings to reverse for one second.
FREE: Factory setting is for 8.2 KOhms. In this case safety edge
must be installed or a 8.2 KOhms resistor must be
connected.
LINKED: used for emergency stop switch, in this case the pre-
installed resistor has to be removed from terminals and
replaced by a suitable switch or terminals have to be
bridged.
Open / Ped
Defines if key switch operates only one wing (Master) or both wings
FREE: only one wing (Master)
-
+
LINKED: both wings
2
or more.
-
+
MOTOR MOTOR 24V/150mA
BR
30VDC
MASTER SECOND / LAMP
+ -
1/2 MOTOR
STOP/8.2KΩ
OPEN / PED
JP1
JP2