Before You Begin; Technical Data - LiftMaster ART200K Manual Del Usario

AVAILABLE INSTALLATION ACCESSORIES
1. 041ASWG-0482-50
2. LA400-JB40E
3. E-lock
4. Transformer for E-lock
5. Floor locking
6. Stops
7. Safety edge
8. IR Sensor stand
9. Emergency Stop switch
10. Keyswitch
11. External Antenna
12. Remote Controls
13. Wireless keypad
14. Base plate slim

BEFORE YOU BEGIN:

The ART is suitable for use with wide pillars, up to about 30cm in width.Width of doorwing must comply with chart.
The maximum recommended opening angle of the gate is 105 degrees. Ensure that ample space is available next to the drive for the arms and
assembly. Gates exposed to a high wind load must be fixed with an electric lock for additional protection. Gate stops must be installed
There are many important factors when deciding on the correct motor. Assuming a well functioning gate, the initial force is the most difficult
moment. When the gate is moving it generally requires a considerably smaller amount of force.
Gate Size: Gate size is an important factor. Wind can slow down gate or distort it, leading to higher amount of required force.
Gate weight: Specification of gate weight represents only a rough parameter, which can vary according to actual demand. Operation is
important.
Influence of temperature: Low outdoor temperatures can impede or even prevent starting torque (ground deformation etc.). High outdoor
temperatures can lead to premature initiation of temperature protection (approx. 135°)
Attention: Motors are not designed to run continuously (continuous operation). The motor warms up and can reach a temperature at which it
shuts down until operating temperature is reached again. Outside temperature and gate represent important parameters for actual operating
duration.

TECHNICAL DATA:

Motor voltage
Nominal power
Max. power
Current nom.
Current max.
Torque max.
Opening time 90°
Cycles/h
Consecutive cycles max.
Operating temperature
Degree of protection
Weight
50m roll of installation cable, 6-pole for
outdoor use, Laying possible without
cable duct with the identical wire colours
as motor
Kit for cable extension of one installation
unit. Consists of 12m of cable 6-pole with
identical colours, distribution box IP65,
cable screw joints and fastening material
203285 (12Volts)
207399
203339 (in combination with E-lock)
for wings 203315 (standard) and 203322
(high)
600046 2.5m set of safety edge
(profile & rail)
600053 20m of rubber profile (small)
600077 20m of mounting rail
600077-1 2m of mounting rail
600060 Assembly pack is required for
each safety edge
600008 single, height 530mm
600084 plastic enclosure, IP65
100034 2-Function, flush-mount
100041 2-Function, surface-mount
ANT4X-1LM
94330E 1-channel
94333E 3-channel
94334E 4-channel, mini
94335E 3-channel, mini
9747E
ART-6
24V
10W
40W
0,5A
1,3A
200Nm
~16 sec.
~ 20
8
-20°C - +55°C
IP44
8kg
1
5
6
4
3
8
9
13
14
2
10
3x
11
7
12