Hilti SC 60W-A36 Manual Del Usuario página 20

1. Remove the battery. → page 11
2. Insert the hex key into the saw blade clamping screw.
3. Press and hold down the spindle lock button.
4. Turn the saw blade clamping screw with the hex key until the spindle lock
button engages fully.
5. Release the clamping screw by turning the hex key in the direction of the
direction-of-rotation arrow.
6. Remove the clamping screw from the outer clamping flange.
7. Open the pivoting guard by swinging it to the side and then remove the
saw blade.
8. Fit the outer flange by turning it in the direction opposite to that of the
direction-of-rotation arrow.
5.3 Installing the saw blade
Use only saw blades of a diameter corresponding to the markings on
the saw.
1. Remove the battery. → page 11
2. Clean the mounting flange and the clamping flange.
3. Slip the mounting flange right way round on to the arbor.
4. Open the pivoting guard.
5. Insert the new saw blade.
Note the direction-of-rotation arrows on the saw blade and on the
product. They must point in the same direction.
6. Install the outer clamping flange the right way round.
7. Insert the clamping screw.
8. Insert the hex key into the saw blade clamping screw.
9. Press the spindle lock button.
10. S ecure the clamping flange with the clamping screw by turning the hex
key in the direction opposite to the direction-of-rotation arrow.
◁ The spindle lock button engages.
11. B efore using the power tool, check that the saw blade is correctly seated
and tightened securely.
12. I nsert the hex key into the hole provided for the purpose.
5.4 Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever.
2. Set the cutting depth.
◁ The cutting depth is shown on the cutting depth scale.
For a clean-edged cut, set cutting depth to the thickness of the
material plus 2 mm.
3. Secure the cutting depth adjustment clamping lever.
12 English
Printed: 04.06.2018 | Doc-Nr: PUB / 5389747 / 000 / 01
4
5
2172267
*2172267*