UFESA AP9000 Manual De Instrucciones página 19

If the SAFBAG holder is not attached
properly, the safety lock will prevent
covering the container with the filtration
unit.
● Prepare the vacuum cleaner for operation according
B
to section .
4
The vacuum cleaner starts at the same power level
it had been working before it was turned off. Set the
desired power value by pressing the power adjustment
buttons +/- (9).
The vacuum cleaner is equipped with
a power level memory function. When
you turn off the vacuum cleaner using
the ON/OFF button (8), the power level is going
to be stored in memory. After the vacuum
cleaner is turned on next time, it is going to start
working at the same power level it had been
working before it was turned off.
The vacuum cleaner is equipped with the
adjustment function for LED brightness
of the power level indicator (10) and the
clogged air inlet indicator (12) situated on the
control panel. To set demanded brightness of
LEDs you should simultaneously press the
power adjustment buttons + and – (9), and then
holding them down you should turn on the
vacuum cleaner by pressing the "ON/OFF"
button (8). The LED for power levels 1, 3, and 5
turn on, and the motor stays turned off. Next by
pressing the power adjustment buttons +/– (9)
you can respectively increase or decrease the
brightness of power level indicator (10), and the
clogged air inlet indicator (12). It is not possible
to change LED brightness for the pump
operation indicator (6). After setting a desired
LED brightness, it is necessary to turn off the
vacuum cleaner using the ON/OFF button (8).
In this way you leave the LED brightness
adjustment function mode, and the set LED
brightness level is stored.
The vacuum cleaner is equipped with
a power limiting function should the inlet
opening be clogged or the SAFBAG dust
bag full. It is manifested by a pulsing limitation
of the motor power and the lighting up of the
clogged air inlet indicator (12) while the vacuum
cleaner is operating at full power. In such a case
switch off the vacuum cleaner by pressing the
on/off button (8), unplug the appliance and
clear the tubes or replace the SAFBAG dust bag.
SAFBAG dust bag disassembly/assembly
1
Remove the filtration unit from the container and
pull out the SAFBAG holder (21).
2
Lift the SAFBAG tab and slide the dust bag from
the holder guide.
3
Slide the new SAFBAG tab all the way into the
holder guide as directed by the arrow printed on the
bag until tab locks in the guide.
4
Put the SAFBAG holder (21) in the container
and cover with the filtration unit in accordance with
paragraphs C2 and C3.
If the SAFBAG dust bag is not properly
attached to the holder, the safety lock
will prevent covering the container with
the filtration unit.
VACUUM CLEANING WITH THE USE OF
THE WATER FILTER MODULE
1
Press and hold the container lid opening button (2)
and lift the container lid.
2
Insert the partition in the container. Make sure the
partition is inserted correctly in the container guide slots
and the safety lock is engaged.
3
Fill the container with 1,3–1,5 liter of water. The water
level should be in the range marked on the wall of the
container.
Do not operate the appliance with an
empty container while vacuum cleaning
with the use of the water filter module.
4
Cover the container with the filtration unit.
If the partition is not inserted properly,
the safety lock will prevent covering the
container with the filtration unit.
● Prepare the vacuum cleaner for operation according
B
to section .
● The vacuum cleaner starts at the same power level
it had been working before it was turned off. Set the
desired power value by pressing the power adjustment
buttons +/- (9).
D
E