UFESA AP9000 Manual De Instrucciones página 21

air inlet indicator (12). In such a case switch off
the vacuum cleaner by pressing the on/off
button (8), unplug the appliance, clean the filter
and empty the container.
Make sure the carpet is not soaked.
It may lead to a permanent deformation
of the carpet (folding).
PICKING UP WATER
If you want to use the vacuum cleaner to vacuum
liquid in the container, the vacuum cleaner should be
prepared as in the case of vacuum cleaning with the
use of the water filter module except that:
1. The container should be empty (without water).
2. You are to use atomizing nozzles (large or small),
large atomizing nozzle with the gathering attachment
or the nozzle for picking up water.
Do not operate the vacuum cleaner with
a full container! Do not vacuum large
amounts of liquid at a time (e.g. with the
hose immersed into water).
If the water exceeds the maximum level during
vacuuming, the float will automatically block the suction.
The maximum capacity of the container is about 5 l.
In such a case proceed in the manner described above
in the part concerning the blocking of suction caused by
a dirty foam filter (pulsating motor speed).
END OF OPERATION CLEANING AND
MAINTENANCE
● Switch off the vacuum cleaner by pressing the on/off
button (8) and unplug the appliance.
● Wind the cord by pressing the cord rewind button (9).
While doing this hold the cord to make sure it is not
tangled and the plug does not hit the vacuum cleaner
housing.
● Turn the end of the hose until the tops of the marks
on the end of the hose end and on the vacuum
cleaner housing are in the same position and pull the
hose out of the opening.
● Remove the stub pipe of the hose by pressing the
red button on the valve and pull the stub pipe.
● Disconnect the telescopic tube from the hose and
the nozzle or brush.
● Pour the dirty water out of the container.
● It is recommended to wash the container, filters
(disassembly below) and partition thoroughly after
each use – changing water several times.
● After using the wet cleaning function thoroughly
wash all attachments used in this process (hose, tubes,
accessories).
If you do not clean the above-mentioned
parts or clean them insufficiently it may
lead to the loss of the filtration
capabilities of the inserts and foam and cause
the formation of bacteria and mites. Dry all the
cleaned parts thoroughly before reassembly.
FILTER DISASSEMBLY
FOAM FILTER I
1
Open the lid of the filtration unit by pulling the
handle upwards.
2
Take out the filtration, wash it under running water,
dry and reinsert.
● Close the filtration unit lid by pressing it until you
hear a characteristic click.
FOAM FILTER II
It is recommended to wear rubber protective gloves
while dismantling the filter.
1
Grab the foam filter with your fingers and remove it
from the filtration unit body.
2
Wash under running water, dry and reinsert.
Do not hand wash the filter foam, do not
wring it, do not wash it in washing
machines. Avoid crumpling, stretching
and deforming. After cleaning dry the foam in
room temperature. Never dry the foam on
heaters, stoves, etc.
EPA OUTLET FILTER AND COOLING AIR FILTER
The EPA outlet filter should be replaced after about
30 hours of operation (6 months) or earlier in case of
heavy dirt.
1
Slide the slider of the filter cover interlock downwards
and open the filter cover.
2
Remove and replace the EPA filter with a new one
when the filter becomes dirty.
3
Remove and replace the motor filter with a new
one when the filter becomes dirty.
4
It is possible to rinse the EPA filter and the cooling
air filter under running water. Remember to dry the
above mentioned filters before reassembly.
● Close the filter cover and slide the interlock slider
upwards.
G
H
I