UFESA AP9000 Manual De Instrucciones página 20

Do not operate the appliance for too
long without replacing the water in the
container.
WET VACUUMING AND WET CLEANING
Before using the wet cleaning function thoroughly
vacuum the surface to be cleaned.
Before operating the vacuum cleaner make sure the
container is empty and the water filter module and the
filters are clean.
1
Press and hold the container lid opening button (2)
and lift the container lid.
2
Remove the container together with the water filter
module (filtration unit and partition) from the vacuum
cleaner.
3
Remove the cleaning liquid container (24) by pulling
it by the handle and lifting it upwards.
4
Open the filler cap and fill the cleaning liquid
container reservoir (24) with cleaning agent (a mixture
of cleaning fluid G 500 O Tens (30) and cold water).
Use the amounts stated on the fluid bottle label:
– "G 500 O Tens" manufactured by BUZIL, Germany.
● Close the filler hole of cleaning liquid container with
the cap.
Before wet cleaning the carpet, check the
colour fasteness of cleaned carpet. Put
a small amount of prepared solution on
white cloth and clean manually the carpet at
least visible place. If the cloth is dyed, it means
that the carpet colours are not permanent and
the carpet cannot be cleaned using cleaning
fluid G 500 O Tens.
5
Insert the cleaning liquid container (24) back to
the previous position and press the container to fix it
correctly (proceed in the reverse order as in case of
removing the container).
6
Insert the container together with the water filter
module (filtration unit and partition) to the vacuum cleaner.
For protection against the formation of foam or at its
formation, when cleaning fill the rear container with
an anti-foaming agent (30) in the amounts specified
on the label:
– "G 478 Buz® Defoam" manufactured by company
BUZIL, Germany.
● Prepare the vacuum cleaner for operation according
B
to section .
Use only the large or small atomizing
nozzle for wet vacuum cleaning.
● The vacuum cleaner starts at the same power level
it had been working before it was turned off. Set the
F
desired power value by pressing the power adjustment
buttons +/- (9).
7
Press the pump switch (7).
The pump may only be switched on
when the cleaning liquid container is
filled with the solution of cleaning liquid
and water. The lack of cleaning liquid manifests
in a loud operation of the pump.
If the nozzle does not atomize water although the
pump is switched on, check if the following items
are correctly installed: the cleaning liquid container
(press the container), the fastening of the stub pipe
in the valve in the base of the vacuum cleaner or the
fastening of the hose end in the atomizing nozzle,
check if the atomizing nozzle is not clogged.
8
Press the button adjusting the inflow of water to
the nozzle on the hose handle.
If you press the button in a pulsating manner, the water
shall temporarily flow in a slower manner to the nozzle,
if you press and slide the button backwards, the water
shall be continuously supplied to the nozzle.
The handle is also equipped with a slider to adjust
the suction power. Do not uncover this opening while
picking up water or using the wet cleaning function.
Do not spray the cleaning liquid in one
place on the carpet for too long in order
not to soak the carpet.
● You should to clean the carpet in such a way that
during and immediately after cleaning nobody walks
on the cleaned surface. After cleaning one part of the
carpet stop the spraying process and dry the carpet
by sliding the nozzle back and forth. Repeat until the
whole surface of the carpet is dried.
● After ending the spraying process switch off the
pump and press the button adjusting the water inflow
to the nozzle for a moment to "release the pressure".
The vacuum cleaner is equipped with
a float which will automatically block the
suction if the foam filter II (32) is heavily
dirty or the liquid exceeds the maximum level.
It is manifested by a pulsing limitation of the
motor power and the lighting up of the clogged