Remove The Communication Cable Knock-Out - Rain Bird IQ Satellite Guía De Instalación Y Usuario

Remove the Communication Cable
Knock-out
1 Using a screwdriver or other pointed tool, punch
through and remove the communications cable
knock-out located on the bottom-left of the
controller case next to the transformer primary
power wiring junction box.
2 Route the communications cable (IQ-DTC-RJ11
cable shown) up through the knock-out hole,
leaving enough slack to connect to the DTC-LXM
Communications Cartridge with the front panel
open.
CAUTION! Ensure that the ground wire and
communications cable do not contact the
transformer directly. Heat from the
transformer may damage the insulation.
IQ LXM-DTC Satellite Controller
1 2
9