SOMFY AXOVIA SGA 2000 Manual Del Usuario página 23

2
Parametering your SGA/AXOVIA
•
Automatic mode :
The gate closes by itself after your passage, without pushing again on the remote control,
after a time that you have previously defined.
The automatic mode will be operational after wiring the cells and the following setting :
1 • Place a remote control as close
as possible to the target engra-
ved on the motorization hood.
> The AUTO light goes off.
2
• Hold down the button designed
for opening both leaves until the
AUTO light is lit. Release.
> The AUTO light blinks.
3 • Start opening (normal distance)
with the remote control.
> The gate opens at the nominal
speed.
4
• Once the gate is completely open :
- Wait for the desired time delay.
- Launch a closing order by pushing again on the same button.
> Both leaves close almost simultaneously.
> The AUTO light remains permanently lit.
The automatic mode is now operational.
Using your SGA/AXOVIA
I Sequential mode functioning
G
Total opening functioning
• Make a long press on remote control
> the two leaves must open.
A new press (short or long) order the
closing of the leaves.
G
Pedestrian opening functioning (if
programmed)
• Make a short press on remote control
> Only the covering leaf must open. A new
press (short or long) order the closing of
the leaf.
I Functionning in automatic mode
I n a u t o m a t i c f u n c t i o n i n g , p u s h i n g o n t h e re m o t e c o n t ro l b u t t o n p ro v o k e s
o p e n i n g o f t h e g a t e . I t s c l o s u re i s d o n e a u t o m a t i c a l l y a f t e r a t i m e d e l a y
p re v i o u s l y a d j u s t e d b y y o u .
STOP
It is possible to maintain the gate in the
open position by giving a short press
order on remote control key during
temporisation
A new press on remote control key
STOP
closes the gate.
STOP
STOP
STOP
23