Installation Procedure; Installation Of Control Console - Gaggenau VR 414 610 Instrucciones De Instalación

For flush mounting:

Installation Procedure

Installation of control console

Note: Only install the appliance in conjunction with
the corresponding control console.
1 Remove the packaging of the control knobs and
the protective film from the light rings.
2 Open the cover of the terminal box on the control
console. Secure the mains connecting lead as
shown in the terminal diagram and secure it with
pull relief. Close the terminal box cover.
3 Hold the retaining plate against the front panel
from behind. Stick the control knobs into the
holes from the front and screw it tight from
behind with the nuts. Make sure that the control
knobs are correctly arranged.
4 Screw the control console tight to the retaining
plate using the nuts included.
9