Installation Procedure - Fisher Scientific Isotemp 13-247-10 Manual Del Usuario

U I
NPACKING AND NSTALLATION
Figure 1
Top rear edge of dual unit
Wall bracket
Top rear edge of dual unit
Wall bracket
10
Wall
or
Wall
• Be level and capable of supporting the weight of
the unit when loaded with samples.
• Be free of drafts and wide ambient temperature
variations such as near a heater or air condition-
ing vents.
• Be near sufficient counter space for sample
preparation, loading, and unloading.
• Provide a fume hood if hazardous fumes are
anticipated when using the hybridization incuba-
tor.

Installation Procedure

1. Carefully unpack the unit and check contents
against the packing list.
2. Remove all packaging material before using the
incubator.
3. Place incubator on a stable, level surface. To
ensure stability of Dual Models (13-247-30, -31,
-32, -33), secure unit to a wall using the includ-
ed wall bracket.
4. Install rotisserie or rocker.
5. Install drip tray inside incubator chamber.
6. Plug the power cord into a suitable grounded
electrical outlet.
7. Check out system operation before using unit.
8. Complete and return the warranty card.