Alpine CDA-7990R Guía De Instalación Y Conexiones página 5

Accessories
Power cord
Installation
1
Bracket
Remove the Detachable Front Panel (refer to page 6 of Owner's Manual). Slide mounting
sleeve from main unit and remove the front frame (see "Removal" on page 6). Slide the mount-
ing sleeve into the dashboard.
2
Metal Mounting
Strap
When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDA-
7990R and put the Rubber Cap on the hex bolt.
If your vehicle does not have the Mounting Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the leads of the CDA-7990R according to details
described in the "Connections" section.
NOTE
For the screw , provide a proper screw to the chassis installing location.
All manuals and user guides at all-guides.com
Flat screw Rubber Cap
(M5 x 6)
x 4
Dashboard
Mounting Sleeve
(Included)
Hex Nut (M5)
Hex Bolt
Rubber Cap (Included)
Hex Bolt (Included)
CDA-7990R
Screw
Bolt Stud
CDA-7990R
ISO Antenna
Convertor plug
5
-EN