Basic Connection - Alpine CDA-7990R Guía De Instalación Y Conexiones

Connections

• Basic Connection

< DC-DC Converter >
NOTES
• Do not install the DC-DC converter where it will be exposed to moisture such as under the floor mat or near the air
conditioner. This may cause a malfunction.
• Do not bundle the DC-DC converter cable with the audio cables. Noise may be induced into your system.
• Keep the DC-DC converter away from the Antenna cables and the rear side of the unit, otherwise noise may be
generated when receiving radio broadcast.
• The DC-DC converter temperature can become hot. This is not a malfunction.
Caution on handling the battery fuse section
5A
Screws
All manuals and user guides at all-guides.com
Cable Color
• Digital Output Connector
Connect this to any other optical digital products of ALPINE.
The digital signal will be output when the CD mode is on.
• Ai-NET Connector
Connect this to the output or input connector of other product (CD Changer,
Equalizer, etc.) equipped with Ai-NET.
• Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
• Remote Control Interface Connector
To remote control interface box.
• Subwoofer RCA Connectors
(L)
White
RED is right and WHITE is left.
Red
When the subwoofer is connected, set the SUB-W to "ON".
(R)
(L)
White
• Rear Output RCA Connectors
Red
RED is right and WHITE is left.
(R)
(L)
White
• Front Output RCA Connectors
Red RED is right and WHITE is left.
(R)
• Audio Interrupt In Lead
Pink/
Connect this lead to the Audio Interface output of a cellular phone which provides
Black
ground shorting when a call is received.
• Remote Turn-On Lead
Blue/
Connect this lead to the remote turn-on lead of your amplifier or signal processor.
White
• Power Antenna Lead
Blue
Connect this lead to the +B terminal of your power antenna, if applicable.
• Illumination Lead
This lead may be connected to the vehicle's instrument cluster illumination lead.
Orange
This will enable the vehicle's dimmer control to dim the backlighting of the
CDA-7990R.
• Ground Lead
Connect this lead to a good chassis ground on the vehicle. Make sure the
Black
connection is made to bare metal and is securely fastened using the sheet metal
screw provided.
• Switched Power Lead (Ignition)
Connect this lead to an open terminal on the vehicle's fuse box or another unused
Red
power source which provides (+)12V only when the ignition is turned on or in the
accessory position.
Fuse
• Battery Lead
Yellow
Connect this lead to the positive (+) post of the vehicle's battery.
(5A)
Choke Coil
• Ground Lead
Connect this lead to a good chassis ground on the vehicle. Make sure the
Black
connection is made to bare metal and is securely fastened using the sheet metal
screw provided.
Fuse
Yellow
• Battery Lead
(5A) Connect this lead to the positive (+) post of the vehicle's battery.
Be careful not to apply excessive force. Doing so may cause the screw connecting the
battery cord and fuse section to loosen and the battery cord to come detached.
Cable Specifications
7
-EN