Batteries; Pb-Acid; Gel; Fuses And Thermal Breakers - Lavorwash EASY-R 45BT Manual Del Usaurio

8.6 BATTERIES

8.6.1 PB-ACID

Carry out maintenance operations in accordance with
the manufacturer's instructions and with all the other
instructions provided in this manual.
Exposing the element plates (not completely immer-
sed in the acid solution) will lead to rapid oxidation and
irreparably reduce the element's operating capacities.
An overflowing acid solution may corrode the machine.
Use battery chargers recommended by the manu-
facturer and, in any case, those that are suitable
for the type of battery to be charged.
Always charge batteries in well-ventilated rooms:
there is an explosion risk!
The use of gel or maintenance-free batteries is hi-
ghly recommended.

8.6.2 GEL

Carry out maintenance operations in accordance
with the manufacturer's instructions and with all the
other instructions provided in this manual.
Use only those battery chargers recommended by
Remove and wash the squeegee
Drain the recovery tank
Drain, rinse with clean water or sanificate the re-
covery tank
Charge the batteries
Check the acid level in the battery cells (if batte-
ries are not maintenance-free)
Check the wear of the squeegee rubber blades
Open and clean the suction filter
Remove brushes and check for brush wear, foreign
bodies and wrapped belts
Verify the machine general conditions.
Open and clean the solution water filter
Verify that suction hose and conduct are free
from obstructions
Check and clean the pivoting wheels
Check wear and function of traction drive belt or
chain; if necessary, adjust belt or chain tension
Clean the brush plate, squeegee support and
squeegee
Check the lifting/lowering of the brush plate.
Check the lifting/lowering of the squeegee.
Grease the moving parts.
Check the control cable for the opening of the solu-
tion water tap.
Descale water hoses.
the manufacturer.

8.7 FUSES AND THERMAL BREAKERS

The machine is equipped with electric protection
devices on the main operating components to avoid
costly malfunctions.
Thermal cutouts are installed to protect the drive
motor wherever foreseen and the brush motor.
When one of these breakers trips automatically, the
disabled function can be reactivated by fully de-
pressing the breaker that tripped.
When the thermal breakers trip, especially when
the machine is used during the first few weeks, it
might not be caused by actual machine malfun-
ctions. However, a specialised technician should
check the device if the relative breaker continues
to trip.

8.8 PERIODIC MAINTENANCE

For all the operations described herein, refer to the
instructions and detailed warnings in the relative
sections.
When After
needed every use
X
X
X
X X
X
X
X
X
X
34
Weekly Monthly
X
X
X
X
X
X
X
X
X
X