Look 795 RS Serie Manual De Montaje página 29

4 / Pass the rear brake sheath (cf. § AEROLIGHT rear brake version) in AEROLIGHT or (cf. §
LIGHT rear brake version) in LIGHT.
Size
XS
S
M
L
XL
5 / Refit the end cap (F) (see end stop / liner guide paragraph).
6 / If your bike is a 795 RS AEROLIGHT, pass the front brake sheath through ① (Fig.2) (cf. fork
HSC8 EVO paragraph).
N.B. : Before going any further, you must fit the ADH2 handlebar and AEROSTEM stem (see
relevant instructions)..
7 / Position the rear derailleur cable starting from the shifter and bring it out through ⑦ (Fig. 1).
Thread over the cable the stop (C) and the liner.
8 / Overlap the liner at ⑩ (Fig. 1) by approx. 5 cm.
9 / You can add a front derailleur tensioner. In this case, cut your front derailleur casing
approx. 3 cm from where it comes out of the tube, then position the tensioner. Position the front
derailleur cable starting from the shifter and bring it out through ⑩ (Fig. 1), then install the liner
pass / angle outlet thread (D).
10 / Complete the installation.
Electrical cable routing : configuration C (AEROLIGHT) and D (LIGHT)
1 / Remove the derailleur end cap (F)
2 / Pull off the two black mechanical routing liners.
3 / Route your electrical groupset using the white pre-routing tubes and following Shimano
recommendations.
Installing the routing (ctd)
Lengths of the foam tube included in the sheath kit
Sort foam tube (x2)
40 cm
41 cm
42 cm
43 cm
44 cm
Long foam tube (x1)
50 cm
51 cm
52 cm
53 cm
54 cm
EN
27