Adjusting The Brake - Look 795 RS Serie Manual De Montaje

NOTE : If you do not have ADH2 handlebars,
replace step 5 with steps 4.1 and 4.2.
4.1. / Position a tube from the brake lever along
the handlebars, cut it 30 mm from the stem and
insert a sheath end (Fig.21).
4.2 / Position the quick-release (optional) at the
end of this sheath, making sure it is correctly
positioned (Fig. 22), then slide the brake cable
into the assembly.
Then slide the cable into the sheath positioned
in the pivot until it comes out between the
arms of the fork.

ADJUSTING THE BRAKE :

1
2
3
Fig. 23
1,5 // 2 mm
If you are using wide rims (> 24mm) remove the washers between the
shoe supports and the internal levers.
1. Adjusting shoe guards (3mm Allen key, Fig. 23): rotate clockwise
and the shoe will move away from the rim; rotate anticlockwise and it will
move closer to the rim.
2. Adjusting shoe positions (4mm Allen key, Fig. 24).
3. Adjusting spring tension (2mm Allen key, Fig. 25): adjust the tension
of the springs to make the movement of the levers symmetrical.
Angle of
attack of
shoe :
0,5 mm
Quick-release :
closed position
Fig. 24
Direction
of rotation
of wheel
NO
Fig. 21
30 mm
Fig. 22
Fig. 25
û ü
OK
EN
37