Look 795 RS Serie Manual De Montaje página 30

EN
4 / Connect the junction box (JUNCTION – A) and position on the cap (see § cap assembly).
5 / Pass through the rear derailleur casing (see rear break AEROLIGHT electronic version paragraph
if you have an AEROLIGHT or the rear brake LIGHT version paragraph if you have a LIGHT.
6 / Refit the end cap (F) (see end cap / liner guide paragraph).
N.B. : Before going any further, you must fit the ADH2 handlebar and AEROSTEM stem (see
relevant instructions).
7 / If your bike is a 795 RS AEROLIGHT, pass the front brake liner through opening ① (Fig.2) (see
fork HSC8 EVO paragraph).
8 / Pass electric grommet (E) through opening ⑦ (Fig.1).
9 / Thread in the front derailleur electrical cable and take it out through opening ⑩ (Fig.1), then
install the pass liner / electrical cable angle opening (D).
10 / Complete the installation.
WIRELESS electric cable routing configurations E ( AEROLIGHT) and F ( LIGHT)
1 / Remove the derailleur end stop (F)
2 / Pull off the two black mechanical routing liners.
3 / Thread through the rear derailleur casing (see rear break AEROLIGHT electronic version
paragraph if you have an AEROLIGHT or rear brake LIGHT version paragraph for LIGHT).
4 / Refit the end stop (F) (see § end stop / liner guide).
5 / If your bike is a 795 RS AEROLIGHT, pass the front brake liner through opening ① (Fig.2) (see
fork HSC8 EVO paragraph).
N.B. : Before going any further, you must fit the ADH2 handlebars and the AEROSTEM stem
(see relevant instructions).
6 / Install the groupset, following the manufacturer's recommendations.
7 / Locate the Ø7.5 plug (H) in opening ⑦ (Fig.1).
8 / Locate the Ø8 plug (I) in opening ⑩ (Fig.1).
9 / Complete installation.
28
Installing routing (ctd)