Adjustable Stops - Look 795 RS Serie Manual De Montaje

Fitting
1 / Make sure the end stop is in the open
position.
2 / Position the stop in its housing against the
composite wall of the frame.
3 / Tighten the tensioning screw to 1 Nm until
the stop is fully held in its housing (Fig. 10.1).
Over-tightening of the
PLEASE NOTE :
tensioning screw can damage its threads
or the holding spring. The stop or its
release may be loosened
Dismantling
1 / Remove the sheath if lodged in the end
cap.
2 / Loosen the tensioning screw until it
comes away from the end stop.
3 / Take out the stop. If the stop is difficult to
remove, loosen the tensioning screw further.
PLEASE NOTE : The end of the tensioning screw is flattened in order to prevent the holding
spring from becoming loose on release, otherwise the tensioning spring may come out and
its threads or those of the tensioning screw can be damaged. This may cause loosening or
disengaging of the stop.
Adjustable stop
Fig. 10.1
Holding spring
Tensioning screw
Fig. 10.2
EN
Frame
Body of end
cap
Cap in position in
its housing
31