User Menu; Pellet Feed Adjustment - Dal Zotto STEFY Manual Usuario

Estufas de pellet
Ocultar thumbs Ver también para STEFY:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

uSer Menu

peLLet FeeD ADjuStMent

The following menu allows the adjustment of pellet feed as a percentage.
If the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board.
The problems correlated to the amount of fuel can be divided into 2 categories:
No FUEL:
Š the stove can never develop a suitable flame, tending to remain very low even at high powers.
Š at minimum power the stove tends to almost switch-off taking the stove into "No PELLETS" alarm condition.
Š when the stove displays the "No PELLETS" alarm, there may be non-burned pellets inside the burn pot.
EXCESS FUEL:
Š the stove develops a very high flame even at low power.
Š the panoramic glass is very dirty, obscuring it almost totally.
Š the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only
burned partially.
The regulation to be performed is a percentage. Therefore a modification of this parameter will lead to a proportional
variation of all stove feeding speeds. Feeding is from -30% to +20%.
Follow the procedure on the display to perform this adjustment:
CoNTroLS ProCEDUrE
Š Press key 5 for a few seconds, until the text SET CLoCk appears.
Š Press key 3 several times to reach SET USEr.
Š Confirm using key 5.
Š Pellet is displayed.
Š By means of the keys 2 and 3 the feeding can be increased (3) or decreased (2) during the Work phase.
Š Press key 1 several times to confirm and exit the Menu.
nO ignitiOn ALArM
FirSt ignitiOn cOuLD even FAiL AS tHe Auger iS eMpty AnD iS nOt ALWAyS ABLe tO LOAD tHe Burn pOt WitH
tHe requireD AMOunt OF peLLetS On tiMe tO reguLArLy StArt tHe FLAMe.
iF tHe prOBLeM OccurS AFter OnLy A FeW MOntHS WOrking, cHeck tHAt rOutine cLeAning StAteD in tHe
StOve BOOkLet, HAS Been cArrieD Out cOrrectLy.
cLeAn cHeck up 1 - 2
SHOuLD tHe ALArM "cLeAn cHeck up" Be triggereD, MAke Sure tHAt
tHe BOttOM OF tHe pOt iS Free OF reSiDueS Or ScALeS.
tHe HOLeS At tHe BOttOM MuSt Be cOMpLeteLy Free tO guArAntee
cOrrect cOMBuStiOn.
(See cHApter "cLeAning unDer uSer'S reSpOnSiBiLity")
tHe ABOve inDicAteD "peLLet FeeD reguLAtiOn" FunctiOn
cAn Be uSeD tO ADjuSt cOMBuStiOn BASeD On tHe DeScriBeD
requireMentS.
iF tHe ALArM perSiStS AnD tHe ABOve LiSteD cOnDitiOnS HAve Been
cHeckeD, cOntAct tHe quALiFieD AFter-SALeS ASSiStAnce centre.
50
engLiSH
BUrN PoT BoTToM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

RitaRita elite

Tabla de contenido