Elvox 68TU/K93 Manual Para El Conexionado Y El Uso página 7

INSTALLATION
Installation of entrance panel (type 13K1), flush-mounting version
- Install the flush-mounting back box (D) on the wall with the bottom edge
at a height of approx. 1.65m from the ground
- Open the entrance panel by loosening the screw underneath the plate
(G) and remove the light diffuser (H).
- Fit the frame (C) to the flush-mounting back box (D)
- Reposition the camera in the frame and the microphone in the special
housing, refitting the plug as shown in Fig. 3.
- Connect the camera to the name card lighting LED board using the two
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if re-
quired) Fig. 3B.
- Make the connections to the installation on the removable terminal block
(L).
In the case of installation for two-family video door entry systems:
- Remove the blanking module (E) Fig. 4, from the back of the plate using
a screwdriver, working in sequence from bottom to top (first remove the
end section, then key 1 and finally the blanking module).
- Fit the external key (F) (supplied) to the plate by pushing it lightly into
place.
- Insert the light diffuser (H) to ensure even lighting of the name cards.
- Remove the lens ring (R) and fit the lens cover (S) (see Fig. 4B).
- Close the entrance panel, securing it to the frame with the aid of a screw-
driver.
Art. 68TC/K, 68TU/K
Fig. 2B
A
C
D
7/32
S
B
GB
G
H
L
I
M
N
O