Elvox 68TU/K93 Manual Para El Conexionado Y El Uso página 8

GB
Fig. 3
Red/black cable
Green/green cable
Fig. 4
3
2
1
Fig. 4B
1
R
Art. 68TC/K, 68TU/K
Fig. 3B
12V
LED CH2
Art. R130)
(
E
Art. R135)
(
2
S
Installation of entrance panel (type 13K1), surface wall-mounting version
- Open the entrance panel by undoing the screw under the plate (G) and
detach the camera (B) from the frame, removing the light diffuser (H)
and the microphone (I).
- Install the frame (C) together with the surface wall-mounting back box
(P) on the wall with the bottom edge at a height of approx. 1.65m from
the ground.
- Reposition the camera in the frame and the microphone in the special
housing (B), refitting the plug as shown in Fig. 3.
- Connect the camera to the name card lighting LED board using the two
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if
required) Fig. 3B.
- Make the connections to the installation on the removable terminal
block (L).
In the case of installation for two-family video door entry systems:
- Remove the blanking module (E) Fig. 4, from the back of the plate using
a screwdriver, working in sequence from bottom to top (first remove the
end section, then key 1 and finally the blanking module.
- Fit the external key (F) (supplied) to the plate by pushing it lightly into
place.
- Insert the light diffuser (H) to ensure even lighting of the name cards.
- Close the entrance panel, securing it to the frame with the aid of a
screwdriver.
F
8/32