How To Change Various Settings - Sharp FX-J80U Manual De Operación

OPERATION 3

HOW TO CHANGE VARIOUS SETTINGS

You can change the functions listed in the table below.
1. Turn the product OFF.
♪ ♪ ♪ ♪ ♪
2. Select
♪
Press for 3 sec.
• You can select F or A.
♪
Product
setting
For details on selecting A, refer to
*
Page 19 - 21.
Set
♪
Function (
Light control
You can select the brightness of the front display
and air quality monitor.
Auto resume
This model has Auto Resume function, where
the operation resumes at the previous operation
mode and settings if the power is restored.
Adjusting sensor sensitivity (F3-F5)
For details, refer to Page 16.
Light sensor
Sensitive dust sensor
Odor sensor
*
When set to "Turn off", the "Dim" light illuminates for 8 seconds after operation starts and then the light turns off.
3. Select "Function Number".
GO BACK
Set
4. Select "Setting Number".
GO BACK
*
Wi-Fi
setting
Set
5. Finish the setting.
)
EN-12
GO FORWARD
♪ ♪
or
♪
GO FORWARD
♪ ♪
or
♪
～
♪
～
Setting (
Turn off *
Dim
Auto
(default)
Light automatically switches based on room brightness.
Front Display and Air Quality Monitor
Room
brightness
Bright
Dark
Cancellation
ON
(default)
Low
Standard
(default)
High
････
See below table for
functions.
See below table for
settings.
Turn off
)
ALL MODE
SLEEP MODE
(Except SLEEP)
ON Dim
Dim Turn off