Using The Grip Ring With Led Light; Notes On Working With Materials/Tools/Speed Range - Parkside PFBS 160 B2 Traducción Del Manual De Instrucciones Original

Using the grip ring with LED light

♦ Unscrew the union nut
thread .
♦ Screw the grip ring with LED
the screw thread .
♦ Move the ON/OFF switch of the LED light
the position "I" to switch it on (see fig . C) .
♦ Move the ON/OFF switch of the LED light
the position "O" to switch it off again .
Notes on working with materials/
tools/speed range
■ Use the milling bit for working on wood, plastics
and plasterboard at maximum speed .
■ Calculate the rotational speed range for working
on zinc, zinc alloys, aluminium, copper and
lead by trying it out on test pieces .
■ Use a low rotational speed for work on plastics
and materials with a low melting point .
■ Use a high rotational speed for working on
wood .
■ Carry out cleaning, polishing and buffing work
in the middle range .
NOTE
► The milling bit is not suitable for steel or
iron . Suitable products are available in stores .
PFBS 160 B2
anticlockwise off the
clockwise onto
to
to
The following are recommendations only and not
binding . When carrying out practical work, carry
out your own tests to see which tool and which
settings are ideal for the material you are working
on .
Set a suitable rotational speed:
Number on the speed
control
1
2–3
4
5
Max.
Material being
worked
Plastics and materials
with a low melting
point
Stone, ceramics
Soft wood, metal
Hardwood
Steel
GB │ MT │ 65 ■