Using the vehicle connector plug
Use the supplied vehicle connector plug
ate the appliance.
♦
To do this, plug the vehicle connector plug
into the 12 V cigarette lighter of your vehicle.
As a rule, this can be found on the dashboard
of your vehicle. Many vehicles have a second
connection by the rear seats or in the boot.
■
The red LED indicates the operating display of
the vehicle connector plug
the vehicle type it is possible that the ignition
has to be switched on first.
■
Insert the battery adapter
connector plug
into the appliance.
■
When you have finished your work, pull the
vehicle connector plug
connection of your vehicle.
NOTE
►
Never connect your appliance without using
your appliance. The device also consumes
power in standby mode and therefore must
be disconnected from the on-board power
supply after use! Otherwise the battery will
discharge when the engine is not running.
Replacing the fuse
There is a fuse in the vehicle connector plug
protect your vehicle's wiring system. If the device
no longer works, check the fuse and replace if
necessary.
♦
Open the vehicle connector plug
fully unscrewing the screw insert anticlockwise
(using pliers if necessary) and removing it.
♦
Remove the plug tip from the fuse and take out
the fuse.
♦
Insert new 15 A fuse in your car charger
adapter.
♦
Fit the plug tip to the slightly protruding end
of the fuse and screw the previously removed
screw insert back in.
│
GB │ IE
■
20
to oper-
. Depending on
of the vehicle
out of the 12 V
to
by care-
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the appliance.
■
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
PHSSA 12 A1