HP LaserJet 300 Manual De Instrucciones página 14

8
Reinstalling the formatter into the HP LaserJet 9040/9050mfp
Figure 1-5
9
When connecting the fax card to a phone line, ensure that the phone
Note
line being used is a dedicated line that is not used by any other devices.
This line should be an analog line because the fax will not function
correctly if connected to some digital PBX systems. If you are unsure
of what type of line you have, contact your telecom provider. Also, HP
recommends using the phone cord that comes with the fax accessory
to ensure the accessory functions correctly.
The phone wall jack is electrified and you might receive an electric
WARNING!
shock if you touch the wall jack. When installing the phone cable, do
not touch the wall phone jack or, if you connect the phone cable into
the wall phone jack first, do not touch the wires on the phone cable
connector at other end.
10 Connect the phone cord connector (1) into the FAX connector (2)
The LAN connector and the phone cord connector are similar. Ensure
Note
that you connect the LAN cable plug (3) into the LAN connector and
the phone cord connector (1) into the FAX connector (2). Note that the
LAN connector is wider than the phone connector.
6 Chapter 1 Setting up
Install the formatter back into the MFP, see Figure 1-5.
Reconnect any cables (4) removed from the formatter in step 4,
see Figure 1-6.
on the formatter plate, see Figure 1-6. Push the connector in until
it "clicks."
ENWW