SOMFY SC 600 II Manual De Instrucciones página 34

SC 600 II
1. Products introduction
Please read the instructions carefully before proceeding.
MCU is supplied to control the gate operator.
Keypad / single button interface.
Have Infrared safety sensor interface.
Soft start and soft stop function and the soft stop width are adjustable.
Working time is adjustable.
Motor output torque is adjustable.
User can select Auto-close function.
Manual key release design for emergency purposes.
2. Important safety information
Carefully read and follow all safety precautions and warning before attempting to install and use this automatic gate operator.
The gate operator should be installed by a qualified technician; otherwise, serious personal injury or property damage may occur.
When opening or closing the gate, do not attempt to walk or drive through the gate.
If enable the auto-close function, must use the infrared sensor.
Children should not be allowed to play near or operate automatic gates.
The automatic gate operator must be grounded.
Install the gate operator on the inside of the property; DO NOT install it on the outside of the property where the public has
access to it.
Be careful when in close proximity to moving parts where hands or fingers could be pinched.
Do not allow control devices to be placed so that a person can access them by reaching through the gate.
In the event of power failure, an emergency release key allows you to operate the gate manually.
The operator should be switched off before repairing it or opening its cover.
Please erase and reprogram the transmitter code after installing the operator.
Make sure the Power supply (AC220V or AC110V) of the gate operator is suitable for the power supply in your area.
3. Main technical parameters
Type
Power supply
Motor speed
Rated output power of
motor
Remote control operating
distance
Remote control mode
Output shaft height
Max. gate weight
Output torque
Limit switch
Noise
Duty cycle
extra remote control
Environmental
temperature
Gate Move speed
SL600AC SL600ACU
220V, 50Hz 110V, 60Hz
55rpm 66rpm
200W
30m (Frequency:433.92mHz)
Single button
48.5mm
600Kg
14N·m
Magnetic limit switch
≤56dB
S2, 15 minutes
20
-20°C~+50°C
12m/min
https://appceso.com
ENGng
33