KOBE Premium Serie Instrucciones De Instalación Y Manual De Operación página 10

For Rear Vent Options only:
NOTE: The blower is pre-installed for top vent. If installing
as rear vent, follow the steps below:
9. For Rear 6" round installation only:
-
Remove the Rear Round Vent Cover and Rear
Rectangular Vent Cover (Refer to Figure 4). Keep screws
to attach Round Exhaust Plate to rear vent.
-
Remove the pre-installed Round Exhaust Plate from top
vent (Refer to Figure 5). Attach it to the rear vent (Refer
to Figure 7) using the screws removed from vent covers.
-
Use the Round and Rectangular vent covers removed
from rear vent to seal top vent.
-
Remove the 4 screws that secure the blower system
(Refer to Figure 8). Hold the blower to keep it from
dropping as you remove screws.
reattached blower. Slowly rotate blower system to align
with mounting holes at the back of the hood. Secure
blower using 4 screws (Refer to Figure 9).
10. For Rear 3-1/4" x 10" rectangular installation only:
-
Remove the Rear Round Vent cover and Rear
Rectangular Vent Cover (Refer to Figure 5). Keep screws
to attach Rectangular Exhaust Plate and Rectangular
Exhaust Adapter.
-
Place the Rectangular Exhaust Plate over vent and
secure with 2 screws (Refer to Figure 10).
Rectangular Exhaust Adapter over the Rectangular
Exhaust Plate and secure with 10 screws (Refer to Figure
10).
-
Use remaining screws to secure exhaust plate.
-
Remove the pre-installed Round Exhaust Plate from top
vent and keep screws (Refer to Figure 4). Use the Round
and Rectangular vent covers removed from rear to seal
top vent.
-
Remove the 4 screws that secure the blower system
(Refer to Figure 8). Hold the blower to keep it from
dropping as you remove screws. Keep screws to reattach
blower. Slowly rotate blower system to align with
mounting holes at the back of the hood. Secure the
blower using 4 screws (Refer to Figure 9).
Ductwork Installtion
11. Determine and make all necessary cuts in the wall or ceiling
for the ductwork. Note: Install the ductwork before installing
the hood
12. Use steel pipe to connect the exhaust on the hood to the
ductwork above. Use duct tape to make all joints secure and
air tight.
13. Please refer to local building codes for the usage of a damper
(not included).
Figure 5
Keep screws to
Figure 6
Place
Figure 7
Figure 8
8