Power Track - Steelcase Thread Manual Del Usuario

®
POWER TRACK INSTALLATION
4.
Inspect the power track for damage. If it is damaged, the power track must be replaced (4a).
Do not remove protective cover until you are ready to make the connection. After removing the
protective cover, make sure the foam seal and terminals are in place and not damaged (4b).
Install the two (2) M4 screws with a T20 torx bit to 7-10 in-lbs torque (4c).
NOTE: The power track can be installed in any of the three (3) available receptacles.
NOTE: Do not anchor tracks to the floor until the entire layout has been placed on the floor, all door
modules installed, all fillers attached and open receptacles for the NEMA monument have been taped off.
TIP: Use chalk line or laser to establish squareness to a wall and layout of the entire system.
DAMAGE

POWER TRACK

4a
PROTECTIVE COVER
4b
4c
Page 13 of 75
FOAM SEAL
RECEPTACLE
24207101 Rev G