Blank Filler; System Installation - Steelcase Thread Manual Del Usuario

®
BLANK FILLER INSTALLATION
WARNING
Risk of Fire or Electric Shock
• Install this blank filler onto any unused receptacle.
8.
Make sure the foam seal is in place and not damaged (8a).
Install the two (2) M4 screws with a T20 torx bit to 7-10 in-lbs
torque (8b).

SYSTEM INSTALLATION

9.
• At this point, the system should have all the power tracks, door fillers, NEMA fillers and blank fillers installed.
Risk of Fire or Electric Shock
• Ensure every receptacle in the system has a filler or power track installed in it.
• For receptacles that have a NEMA filler and are missing the protective cover, place a piece of masking tape over the receptacle if the dust cover is missing
to keep dust out of the connector during the floor anchoring process.
• The next step is to anchor the system to the sub-floor. See page 20 for hardware recommendations for mounting to concrete and wood sub-floors.
WARNING
8a
FOAM SEAL
8b
Page 16 of 75
24207101 Rev G