Filler Usage And Anchor Points - Steelcase Thread Manual Del Usuario

®
SYSTEM INSTALLATION (CONTINUED)
9.

FILLER USAGE AND ANCHOR POINTS

• Each filler must be anchored to the sub-floor
using one (1) of the available holes (shown) in
each module.
• All fillers have break-off tabs for removing the tapered ramps.
Tapered ramps are used for carpeted installations. For conformable
floor covering installations with underlayment, remove tapered ramps
from module by cutting the break-off tabs, then discard the tapered ramps.
See conformable floor covering installation on page 21.
10.
Place the ramps onto the metal raceway if no underlayment is used.
Place track infills onto raceway if using underlayment. No fasteners
required for either type.
BREAK-OFF TABS
FILLER FOR USE
WITH CARPET
MODIFIED FILLER
FOR USE WITH
UNDERLAYMENT
AVAILABLE HOLES.
ANCHOR ONE (1) OF
THESE THREE (3) HOLES.
AVAILABLE HOLES.
ANCHOR ONE (1) OF
THESE TWO (2) HOLES.
(TRACK AND RAMPS INSTALLATION
SHOWN FOR USE WITH CARPET)
AVAILABLE HOLES.
ANCHOR ONE (1) OF
THESE THREE (3) HOLES.
Page 18 of 75
24207101 Rev G