Analogue Output (C.a 63 And 65); Hold Display; Store In Memory - Chauvin Arnoux C.A 61 Manual De Instrucciones

Analogue output (C.A 63 and 65)

A voltage Vo, representing the value measured on the IN terminals, is generated at the OUT
terminals. This analogue output Vo corresponds to 1 mV per °C (Vo = 1 mV/°C x q°C).
Load resistance: ³ 10 kW .

3.2.2 Hold display

measurement display
(IN symbol)
HOLD
hold the display on
the measured value
when the HOLD
button is pressed
(HOLD) symbol)
HOLD

3.2.3 Store in memory

display measurement
(IN symbol)
MEM
3.2.4 Reading and clearing memory
The memorised values (in previous paragraph 3.2.3) can be read or erased as needed.
Changing from one memory number to another, or from one memorised value to another, is
easily done by means of the four move buttons
To learn how to use these possibilities for moving in the memory, a few minutes operation are
worth more than any attempt at explanation.
With the instrument in measurement mode, it can be
useful to hold the display temporarily and read the mea-
sured value at leisure.
mode (IN symbol), press the
Your instrument can memorise up to 50 measured values.
They are automatically numbered from 1 to 50 and can
be read later (next paragraph 3.2.4).
audible beep signalling
the memorisation of the
displayed value
To clear the display and return to measurement
above 50 values, has no effect (neither
beep, nor memorisation).
38
button again.
HOLD
Any attempt to memorise,
.