Service; Before Calling Service; Data Plate; Appliance And Cabinet Cutout Dimensions - Thermador MASTERPIECE Serie Manual De Instrucciones

Service

Before Calling Service

See Use and Care Manual for troubleshooting
information. Refer to the Warranty in the Use and Care
Manual.
To reach a service representative, see the contact
information at the front of the manual. Please be
prepared with the information printed on your product
data plate when calling.

Appliance and Cabinet Cutout Dimensions

Dimensions for 27" Wall-Mounted Units

Single Oven 27"
èç
 PP

 PP

 PP
ê
 PP

 PP

 PP
ë
 PP
 è
 PP

 PP

 PP

Data Plate

The data plate shows the model and serial number. Refer
to the data plate on the appliance when requesting
service.
The data plate is located on the underside of the control
panel:
Wall Installation 27" Ovens:
ê
 PP
It is good practice, when oven is installed at the end of a
cabinet run, adjacent to a perpendicular wall or cabinet
door, to allow at least 1/4" space between the side of the
oven and the wall/door.
For oven support, install 2x4's extending front to back
flush with the bottom and the side of the opening. The
supporting base must be well secured to the floor/
cabinet and level.
NOTICES
The conduit box must be installed either above or
▯
below the unit. If the conduit box is installed below the
unit, a 2" diameter hole or space is required between
the back wall and the right rear of the 2x4 supports.
The cabinet base must be flat and capable of
▯
supporting a weight of at least 193 lbs (87 kg).
é
 PP

 PP
PLQ ë
PD[ 
   PP
13