Diono Radian 3 RXT Manual De Instrucciones página 23

3. Unhook and remove top
tether strap from storage
location 2 on back of seat.
4. Feed LATCH connectors into
forward-facing belt path.
The LATCH connectors are
easier to feed through by
routing behind cover.
5. Place car seat forward-facing
in back seat of the vehicle.
Center the car seat
between the vehicle LATCH
anchors. The entire seat
bottom should sit flat on the
vehicle seat.
6. Loosely attach tether strap. Do
not tighten. Consult vehicle's
owner manual for specific
location.
44
1-855-463-4666
7.
2
3
8. Tighten the LATCH strap.
7 4
9. Test for tightness.
5 5
6 6
Attach LATCH connectors
to vehicle's LATCH anchors
and listen for audible click to
confirm engagement. LATCH
strap should lie flat and not be
twisted.
Press down firmly in the center
of the car seat while tightening
the LATCH strap. You may need
to tighten through the opening
in the cover by the belt path
shown, by own, by pulling it through pulling it through
and up. and up.
Grab the side of the seat with
one hand where the LATCH
strap is and slide the car seat
side-to-side and front-to-back.
If the seat moves less than 1 in.
(2.5 cm), it is tight enough. Do
not test by grasping the top or
front of the seat.
diono.com
8 7
9 8
10 9
45