Diono Radian 3 RXT Manual De Instrucciones página 30

BELT LOCKING CLIP
WARNING:
If your vehicle lap/shoulder belt is equipped
with ELR (Emergency Locking Retractor) that does
not switch to function as an ALR (Automatic Locking
Retractor), you MUST use a locking clip to secure lap
portion of vehicle seat belt. If you have any questions,
please consult your vehicle owner's manual or contact
the vehicle manufacturer.
1. Remove lock clip from back of
seat.
2. Route the vehicle seat belt
through the proper belt path
and buckle it in. While pushing
down on seat, pin the two straps
together behind the buckle
tongue. Unbuckle the belt without
allowing it to slip.
3. Attach locking clip to lap/
shoulder belt as shown.
Rebuckle belt. Check that lap
belt does not move by pulling
hard. If belt loosens or lengthens,
repeat procedure.
58
1-855-463-4666
SafeStop is for use
installations from 22–40 lb (10–18 kg).
DO NOT
1. Detach SafeStop from location
2. Remove harness straps from
1
3. Thread bottom of SafeStop
2
3
ONLY in forward-facing
USE REAR-FACING.
on back of seat.
metal plate. Detach harness from
metal plate on back of seat. Once
detached, thread both harness
straps onto the metal hook of
the SafeStop. Connect left side
of harness first, then follow with
the right.
onto the metal hook of harness
adjuster. Check to ensure proper
engagement to the metal plate.
Take care to ensure harness
straps are not twisted and are
clear from any obstructions.
diono.com
SAFESTOP
3
3
1
2
3
59