Manual Operation - FAAC 595 I/S Manual De Instrucciones

6.5. ADJUSTING TRANSMITTED TORQUE
The 595 I/S operator is fitted with an anti-crushing system to
stop door movement whenever an obstacle is encountered
during movement.
Start garage door opening and adjust operator torque by
means of the green screw (V, fig. 4). Repeat the same
operation for door closing by means of the red screw (R, fig.
4). Correct adjustment is obtained when the door stops with
a torque of approximately 15 kg measured on the lower
edge of the door.
To increase torque, turn the screws clockwise; to reduce
torque, turn screws anti-clockwise.
After completing the adjustments, fit the protective cover
onto the operator and secure using the screws.
6.6. TESTING THE AUTOMATED UNIT
After completing installation, attach the danger warning
labels between the transmission tubes and the telescopic
arms (figs. 8-9). Carry out a careful functional check of the
operator and all accessories connected to it.
Give the customer the "User guide" and demonstrate how
to use the operator correctly. Point out the potential danger
zones of the automated unit.

7. MANUAL OPERATION

If the garage door has to be operated manually due to a
power failure or malfunction of the automation, the knob
release device must be used (fig. 25).
A customised key-operated emergency release can also
be installed outside (fig. 26) (optional).
SBLOCCA/UNLOCK
DEBLOQUE/ENTRIEGELT
DESBLOQUEAR
BLOCCA/LOCK
BLOQUE/VERRIEGELT
BLOQUEAR
SBLOCCA/UNLOCK
DEBLOQUE/ENTRIEGELT
DESBLOQUEAR
BLOCCA/LOCK
BLOQUE/VERRIEGELT
BLOQUEAR
- Insert the key in the lock, and turn the key anticlockwise by
1 turn.
- Manually open or close the door.
8. RETURNING TO NORMAL OPERATION
To prevent an accidental impulse from actuating the garage
door during this operation, before you restore normal
operation, disconnect the system from the power supply.
knob (standard):
- turn the knob clockwise as far as it will go.
customised key (optional):
- turn the key clockwise all the way;
- slowly turn the key anticlockwise up to the point where it
can be extracted.
9. ACCESSORIES
Limit switch kit
The limit switch kit makes it possible to stop the garage door
in two specific positions.
It can be fitted on the FAAC 595 I operator only if the 596
MPS card has been installed on it for this function. When this
requirement has been met, proceed as follows:
1. Extract the shafts from the pinions, and mount the
cams.
2. Remove the screws holding the operator onto the
longitudinal sections, add the flat washers provided
and mount the limit switch supports.
3. Tighten the screws, and fit the limit switches into their
seats.
4. Open the garage door to the required point and turn
cam A of microswitch FCA until it activates the
microswitch.
5. Close the garage door and turn cam B of microswitch
FCC until it activates the microswitch.
6. Tighten the self-tapping screws on the cams.
Fig. 25
Fig. 26
External release device with customised key Figs.12-28
The release device with customised key makes it possible to
actuate the garage door from the outside in case of a
malfunction or breakdown.
19
FCA
FCC
B
ENGLISH
A
Fig. 27