Swing-N-Slide Chesapeake Manual Del Usaurio página 42

BOARD INVENTORY:
Identify the illustrated boards below to build your Monkey Bars set.
19-1/4"
(2) 2" x 4" x 19-1/4''
(2) 2" x 4" x 60''
(2) 2" x 4" x 94''
Fig. 33
ASSEMBLY INSTRUCTIONS
1. On two 2" x 4" x 60" boards, measure and mark five rung positions, centered at intervals shown in (Fig. 33).
Attach Rungs to 2'' x 4''s using (2) 2'' Lag Screws per rung.
2'' Lag screw
FLUSH
(6)
1'' Truss Head
screws
per bracket
60"
2" x 4" x 60"
2" x 4" x 60"
13"
13"
Fig. 34
94"
13"
2" x 4" x 60"
1''Truss Head
screw
2. Position the 2" x 4" x 19-1/4" steps to the inside of
the 2" x 4" x 94'' posts as indicated in (Fig. 35) and
(Fig. 36). Mark the bottom of each step location on the
2" x 4" posts. Attach a step bracket to the posts at each
marked location using three 1-1/4" screws per bracket.
Place 2" x 4" x 19-1/4'' steps on top of brackets and
secure using three 1-1/4" screws per bracket.
3. Secure the steps to the ladder posts using (2) 2-1/2''
screws per joint as shown in (Fig. 35).
4. AttachMonkey Bars Ladder to Monkey Bars assembly
using (2) Boomerang Brackets as shown in (Fig. 34).
42
13"
4-1/2"