Removing The Refrigerator Doors - Samsung RF4289HA Manual Del Usario

• Allow clearance to the
right, left, back and top
when installing.
This will help reduce
power consumption and
keep your energy bills
lower.
• Do not install the refrigerator where the
temperature will go below 50ºF (10ºC).
• Do not locate the refrigerator where it may
become wet.
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above
CAUTION
the fl oor).
Refer to 'Adjusting the doors' in the
manual (on page 9).
Flat-blade screw Flat-blade screw
driver(-) driver(-)
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 359lbs (165kg).
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
DA68-02520A(1.0).indb 07 DA68-02520A(1.0).indb 07
B B
A A
E E
C C
D D
Control Lever Control Lever
ACCESSORIES AND REQUIRED
TOOLS
The following accessories are included with your
refrigerator:
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refi rgerator:
Philips Flat-blade
screwdriver (+) screwdriver (-)
Pliers Allen wrench (3/16") (5mm)
REMOVING THE REFRIGERATOR
DOORS
For some installations you need to remove the
fridge and fl ex doors and the freezer drawer so
you can move the refrigerator to its fi nal location.
Do not remove the doors/drawer if you don't need
to. If you do not need to remove the refrigerator
doors, go to Adjusting the Level on page 9. If you
need to remove the doors. continue below. Before
removing the door/drawer, make sure you read the
following items:
Disconnect power to the refrigerator before
removing the doors or drawer.
WARNING
• Be careful not to drop, damage, or
scratch the doors/drawer while removing
them.
• Be careful not to injure yourself while removing
the doors/drawer.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Fastener
Socket wrench
(10mm)
setting up _07
2012.5.30 10:39:58 AM 2012.5.30 10:39:58 AM