Electric Lock Activation Time - Fermax ADS Manual De Programación

VDS - B VDS - B VDS - B VDS - B US2 US2 US2 US2
VDS - BUS2 VDS - B VDS - B VDS - B VDS - B VDS - BUS2 US2 US2 US2 US2

1.2.- ELECTRIC LOCK ACTIVATION TIME

This parameter can be set up by software programming using the panel keypad (there is
no need to open the outdoor panel).
System allows two different electric lock activation times:
- Door activation from house terminal (monitor and telephone) and the outdoor
panel (using the access control feature):
- Another one related to the door open pushbutton (inside the building) if it is installed.
There are two simple steps to program the electric lock activation time:
1.- Power down and up the system (warm boot). There is only a minute to do the
following steps.
2.- Enter programming code (3 1 4 1) to enable programming mode and four digits:
a. First two digits to set up the activation time related to the dwellings and
outdoor panel.
b. Last two to set up the activation time related to the indoor open pushbutton.
REMARKS:
Activation time range is 1-99 seconds.
Each time is defined by 2 digits, so every time less than 10 seconds must be entered
preceded by a '0'.
On error(-s) in programming process, sequence must be restarted from the beginning
(step 1).
Pag 23