Publicidad
GB
READ AND SAVE THESE INSTRUCTIONS
•
Important Safety Instructions
WARNING – To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-
State Speed Control Devise
•
Installation Instructions
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
•
Installation work and electrical wiring must be done by quali ed person(s) in accordance with
applicable codes and standards, including re-rated construction.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden
utilities.
! WARNING: MANUALS
This product has been designed to operate safely and reliable for several years. However because
of its electronic nature manuals and technical information supplied along with the hand dryer
must be carefully read. Please keep this manual and the rest of information for future consults.
If you transfer the unit to a third party please include manuals and unit technical information.
!! WARNING: ELECTRICAL CIRCUIT:
This unit must be powered by a dedicated circuit branch protected by a circuit breaker with the
appropriate rating:
Model 240V:
Circuit Breaker: 16A
Model 120V:
Circuit Breaker: 25A.
Circuit cable must t current consumption for your product as stated in this manual.
SAFETY AND USE
•
This unit has been designed for indoor use only, covered from water sun and extreme
temperatures do not use it outdoors or close to moisture and heat generators.
•
Minimal distance to water source must be at least 16 inches (40cm).
•
Must be installed following the instructions of this manual.
•
Manufacturer is not responsible for damages caused by misuses or defective installations
•
This hand dryer can only be revised maintained and repaired by trained and authorized
personnel.
•
Always use original pieces and spare parts.
•
Power the hand dryer from appropriate power source according to the acquired equipment.
The unit electrical speci cations plate shows the power rating.
•
Children must be supervised by an adult while using this product.
•
This product is designed for an e cient and quick hand drying. Never try to dry any other part
of the body
•
Foreign objects must not be put neither in nor over the hand dryer
•
Heavy objects must not be put over the hand dryer
•
If this unit fails it must be taken out of order and technical service (or distributor) must be
called for a product check.
•
Inner space of this product is protected and locked by screws so only trained and authorized
personnel should revise this unit. There are neither serviceable nor replaceable parts inside the
unit.
DISPOSAL
Packaging:
Packaging protects the unit in warehouse and transportation. It is made of
recyclable materials. When packaging is no longer needed, dispose it
appropriately according to recycling normative.
When replacing a product:
This unit has been marked with European WEEE symbol. Obsolete or inoperative
units must be disposed according to electric and electronic waste management
normative in your country . This unit must be disposed in an appropriate
manner to avoid potential environmental damages or just for re-cycling some
of their materials. In Europe you must dispose this unit in a recycling centre
in your area or contacting your dealer or local government.
MAINTENANCE
•
External: Can be cleaned using a soft cloth for removing dust over external case. Do not use
scouring agents, glass or all-purpose cleaners. Never immerse the unit in water!
•
Water Tank: Water from drying process is recollected in a tank located in bottom part of the
unit. This unit generates a visual and audible alarm when tank is near high level. If tank is not
emptied water will over ow dropping to the oor. This unit works normally even when high level
alarm is in ON status.
•
Dust Filters: This unit has 2 dust lters (one per motor) which need to be revised and cleaned
periodically. Please consult maintenance section of this manual before performing any maintenance
operation.
INSTALLATION AND OPERATION
Revise related sections of this manual
TABLE OF SPECIFICATIONS
MODEL:
230V
Voltage
220-240V
Frequency
50/60 Hz
Power
1.800 W
Current
8.0A @ 230V ac
Electrical Isolation
Class ll
Air Speed
125 Mph (200 Km/hr)
Drying Time
10-15 s
Dimensions (mm.)
11.81x7.67x24.21 (inches)
Weight
9.3 Kg.
Protection Level
IP33
This unit complies with the recognised regulations of technology and relevant safety directives.
We hereby con rm the conformity with following European directives: 89/336/EEC (92/31EEC)
y 73/23EEC (93/68/EEC).
Subject to modi cations without notice.
120V
110-120V
50/60 Hz
1.880 W
15.9A @ 120V ac
Class ll
125 Mph (200 Km/hr)
10-15 s
11.81x7.67x24.21 (inches)
9.3 Kg.
IP33
5
Publicidad
