Unpacking & Checking Contents; Tools Needed - Dremel 1800 Manual De Instrucciones

Unpacking & Checking Contents
To avoid injury from unexpected starting or
WARNING
!
electrical shock, always remove plug from
wall outlet when tool is not in use.
Model 1800 Scroll Station is shipped complete in one carton.
Separate all "loose parts" from packing materials and check
each item with the "Packing List" to make sure all items are
accounted for before discarding any packing material.
If any parts are missing, do not attempt to
WARNING
!
operate Scroll Station, plug in the power cord
or turn the switch on until the missing parts are obtained and
are installed correctly.
Packing List
Item Description
A 18" Scroll Station ......................................................1
B Owner's Manual ........................................................1
C Parts Bag (containing) ..............................................1
D Side Table with Side Miter ......................................1
E Flat Head Screws....................................................2
F Wing Knobs ............................................................2
G. Flip-up Guard ..........................................................1
Allen Wrench (2 mm, 2.5 mm & 4 mm) ..................1
Drive Screw for Flex Shaft Attachment ..................1
Adaptor for future additions ....................................1
Spacer ....................................................................2
O Ring ....................................................................2
Drive Nut ................................................................1
Blades ............................................................................12
To remove protective coating from the table surface, moisten
a soft cloth with kerosene or WD-40 and wipe off coating. Do
not use acetone, gasoline or lacquer thinner for this purpose.
After removing protective coating, If you wish, you may apply
a coat of paste wax to the table to allow the workpiece to slide
easily across the table surface and deter rust. Wipe the table
thoroughly with a clean dry cloth.
NOTE: Hardware to mount this Scroll Station to a bench or
leg set is NOT supplied. See ASSEMBLY-MOUNTING THE
SCROLL STATION, Page 8, for recommended hardware
size.
IMPORTANT! If you require any assistance with these
instructions, please contact the Dremel Service Department
at:
1-800-437-3635

Tools Needed

Phillips Screwdriver (not included)
Combination Square (not included)
Qty.
G
Combination Square Must be True
1. Use the straight edge of a 3/4" thick board (this edge
must be perfectly straight).
2. Draw a line on the board along this edge.
3. There should be no gap or overlap when the square is
flipped over in dotted position.
8
A
E
D
E
F
Figure 2. Packing List Parts
1
3
F
2