Tabla de contenido
Publicidad
TP888-969-889 Crazywavy IN8029-A 03 09:TP888-969-889 Crazywavy IN8029-A 03 09 11/03/2009 11:50 Page 6
1. ASSEMBLY AND SAFETY INFORMATION
TP toys must be assembled by an adult. They must be erected exactly in accordance with the assembly instructions. Enlisting the aid of a helper
will make assembly easier. This pack may contain small parts and is not suitable for children under 36 months. We recommend that you place
small parts on a tray, or something similar, to prevent the frustration and disappointment of mislaying them. Please take care during assembly as the
manufacturing process can sometimes result in the occasional sharp edge and small pieces of waste metalwork. Should there be any missing parts,
the toy must not be used until replacement parts have been fitted - the TP Customer Services line is +44 (0)1299 872804 (English Speaking).
2. SITING
Under no circumstances should any of our toys be positioned on hard surface such as concrete or asphalt, unless the ground under the toy plus the
recommended freespace area is covered with a safety surface (please refer to diagram on page 15). Examples of suitable surfaces are grass, sand
or a play surface intended for this use. TP toys should be sited on level ground.
3. USAGE
TP toys are designed and made for family outdoor/domestic use only by children aged between 3 and 12 years, unless otherwise stated, and must
not be used by anybody else. Misuse can result in injury.
4. SUPERVISION
Children should always be supervised while they are playing on TP toys and should be instructed not to use the toy in an inappropriate or hazardous
manner. We recommend that they do not wear loose-fitting clothing or jewellery than may catch or snag during play. Children should not wear cycle
helmets while playing on TP toys.
5. WEATHER CONDITIONS
Special care should be taken as weather conditions change. In particular, outdoor toys can become slippery in wet weather and tongues and lips
can stick to metalwork at subzero temperatures. In warmer and sunnier weather, parts can become hot, and the temperature should be regularly
checked during play, especially metal parts and slides. If there is any doubt over safety then the toys should not be used.
6. WATER PLAY
Many surfaces can become slippery during water play. Extra caution and supervision is required when combining water (e.g. paddling pools, aqua
slides etc.) with other forms of outdoor play.
7. MAINTENANCE.
With all toys it is vital that the equipment is checked regularly and often by an adult. The complete toy should be checked at least once a month,
and particular attention should be paid to connections and fastenings. If any parts exhibit signs of wear and tear, they may need to be replaced.
Checks must be carried out at the beginning of the usage season as well as at regular intervals throughout the usage season. Check all nuts and
bolts for tightness and tighten when required. Failure to do this may result in the product malfunctioning and causing injury. Children must not be
allowed to use the toy until properly installed and checked. Galvanised tubular products may require occasional maintenance. If surface rust
appears it should be removed with either a wire brush or coarse sandpaper, and the area treated with a non-toxic paint.
8. SWING FRAMES
These must always be used with the stakes provided. If the stakes do not give enough hold, we recommend that you concrete them in place.
Never set the legs of a swing frame in concrete.
9. SWINGING TOYS
When fitting swinging toys it is vital that moving parts have no metal to metal contact. Children should be instructed not to pass in front of or behind
moving items, not to twist or swing an empty swing seat, and not to get off a swinging toy when it is in motion.
10. ROPES
These ropes will degrade over time. When signs of degradation appear, the toy should be replaced.
11. TRAMPOLINES
We recommend the fitting of safety pads for all trampolines. TP trampolines are designed as toys and should not be used as gymnastic equipment,
unless otherwise stated.
12. FIRE RISKS AND DISPOSAL
Never allow TP toys to be placed or used near a fire. When it becomes necessary to dispose of your equipment, remove all bolts and disassemble.
Store out of the reach of children until it can be properly disposed of.
These instructions are issued in the interest of child safety, and we do ask you to follow our advice.
Made in England by: TP Activity Toys.
INSTRUCTIONS FOR ASSEMBLY,
1
MAINTENANCE AND USE OF TP TOYS
Please read carefully and keep all enclosed information
or future reference.
10
20
30
40
Dimensions in mm
50
60
70
80
90
6
100
Publicidad
Tabla de contenido
