Sun Function; Introduction - SOMFY Sonesse 40 RTS Manual De Instrucciones

5 Sun function

5.1 Introduction

For this function, you need a Telis Soliris
transmitter.
By default, the Sun function is not active.
1) To activate the Sun function, press the
SELECT button on the Telis Soliris transmitter
until the shade jogs.
2) To disactivate the Sun function, press the
SELECT button on the Telis Soliris transmitter
until the shade jogs.
When the intensity of the daylight exceeds the
threshold set by the Soliris sensor RTS, an order
is sent to the shade after 2 min.
The shade goes to the MY position or to its down
limit if no MY position has been memorised.
When the intensity of the daylight falls
below the threshold set by the Soliris sensor
RTS, the shade goes to the sun disappearing
position or stays at its position (MY or Down
limit) if no sun disappearing position has been
memorised.
To set the sun diappearing position, see 6.2 part.
The Wind function is not compatible with this
motor.
Copyright © 2011-2016 Somfy Activités SA,. All rights reserved
1
2
OK
9