Location And Assembly - Scotsman CME1056R Indicaciones Para El Uso

Location & Assembly
Locate the ice machine indoors. Locate the remote
condenser as close as possible to the ice machine. The
best location for the condenser is above the ice machine.
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove the
carton, and using part of the carton as a cushion, tip the
bin on its back to remove the skid and attach the legs or
casters.
Note: Stacked applications may not use casters.
Return the bin to an upright position. Check the bin top
gasket for gaps and tears, fill any in with food grade
sealant prior to placing the ice machine on the bin.
Level the top edge of the bin front to back and left to
right.
If the ice machine has not been unpacked, do so now.
Remove the carton from the skid. After removal of the
shipping straps, lift the ice machine off the skid directly
onto the bin.
Note: The machine is heavy! Use a mechanical hoist if
necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and 4 bolts).
Locate the Bin Thermostat Bracket and hardware. Retain
for later use.
Cabinet Panel Removal:
Note: The top panel holds the upper edges of the side
panels in place.
1. Remove the front panel by removing the two screws
connecting the front panel to the machine, and then
pulling out at the bottom edge.
2. Lift up at the front edge and push (pull for the
CME1056) the top panel back until it releases from the
tabs connecting it to the back panel.
3. Remove the screws at the front edge of the left side
panel, and pull forward until it releases from the tabs
connecting it to the back panel.
4