Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING AND INSPECTION
1.
Call your authorised SCOTSMAN Distributor
or Dealer for proper installation.
2.
Visually inspect the exterior of the packing
and skid. Any severe damage noted should
be reported to the delivering carrier and a
concealed damage claim form filled in
subject to inspection of the contents with the
carrier's representative present.
3.
a) Cut and remove the plastic strip securing
the carton box to the skid.
b) Cut open the top of the carton and remove
the polystyre protection sheet.
c) Pull out the polystyre posts from the
corners and then remove the carton.
4.
Remove the front/top panel of the unit and
inspect for any concealed damage. Notify
carrier of your claim for the concealed
damage as stated in step 2 above.
5.
Remove all internal support packing and
masking tape.
6.
Check that refrigerant lines do not rub
against or touch other lines or surfaces.
7.
See data plate on the rear side of the unit
and
check
that
corresponds with the voltage specified on it.
CAUTION. Incorrect voltage supplied to the
icemaker will void your parts replacement
program.
8.
Cut the manufacturer's registration card from
the back cover page of the User Manual and
fill-in all parts including: Model and Serial
Number taken from the data plate.
Forward
the
registration
EUROPE/Frimont factory.
local
main
voltage
completed
self-addressed
card
to
SCOTSMAN
LOCATION AND LEVELLING
WARNING. This Modular Superflaker is designed
for indoor installation only. Extended periods of
operation at temperature exceeding the following
limitations will constitute misuse under the terms
of
the
SCOTSMAN
Warranty resulting in LOSS of warranty coverage.
1.
Position
the
permanent location.
Criteria for the selection of location include:
Air temperature
Water temperature
Water pressure
Electr. voltage variations from
voltage rating specified
on nameplate
Service access: adequate space must be left for all
service connections through the rear of the ice
maker.
1.
Lay out on the storage bin top the plan of the
ice machine as it will be located on the bin
and cut one or two openings according to the
Ice Maker model.
2.
Install the Modular Superflaker on the
storage bin pay attention to match the ice
chute/s with the Bin Top opening/s.
3.
Level the Ice Maker in both the left to right
and front to rear directions by means of the
adjustable legs.
The machine is also equipped with pre-pounched
rectangular openings on the left side panel so to
have the possibility to discharge the ice through the
side of the machine (not recommended).
3
Manufacturer's
Limited
machine
in
the
selected
MIN
MAX
10°C (50°F)
40°C (100°F)
5°C (40°F)
35°C (90°F)
1 bar (14 psi) 5 bars (70 psi)
-10%
+10%
Publicidad
Tabla de contenido
