Operating Trouble; Spare Parts - Wilo Initial WASTE Instrucciones De Instalación Y Funcionamiento

8.

Operating trouble

ATTENTION! Before any intervention dis-
connect the pump!
Faults
The fails to start
The pump fails to deliver or deliers too
little
The pump trips out
9.

Spare parts

Spares should be ordered through local trade
outlets.
To avoid queries and incorrect orders, all the
data on the name plate must be indicated when
ordering.
10.
Disposal
Information on the collection of used electrical
and electronic products
Proper disposal and appropriate recycling of this
product prevents damage to the environment
and dangers to your personal health.
NOTICE: Disposal in domestic waste is forbid-
den !
In the European Union, this symbol can appear
on the product, the packaging or the accompa-
nying documentation. It means that the electrical
and electronic products in question must not be
disposed of along with domestic waste.
To ensure proper handling, recycling and disposal
of the used products in question, please note the
following points:
• Only hand over these products at designated,
certified collecting points.
• Observe the locally applicable regulations!
Please consult your local municipality, the near-
est waste disposal site, or the dealer who sold
the product to you for information on proper
disposal. For further information on recycling, go
to www.wilo-recycling.com.
Subject to technical alterations!
Installation and operating instructions - Wilo-Initial DRAIN
Causes
No current
Winding or cable open-circuit
Rotor stalled (the motor "growls")
Discharge pipe obstructed
Impeller obstructed by particles
The check valve is mounted
upside down
Faulty electrical installation
Pump stalled
The pump is hard to turn
Remedies
Check the line. Replace the fuses if
necessary. Close the overload release or
the switch of the control box
Check the resistances between the cable
ends; if necessary replace the cable
(Caution: in case of replacing, reconnect
correctly the supply wires according to
the colours)
Allow to cool downDismantle the impel-
ler and clean it
Remove the pipe and clean it
(See 8.1 - c)
Check it
Check the whole electrical installation
(See 8.1 - c)
(See 8.1 - c)
English
11