Before Use; Filling With Water - Rowenta ULTRASTEAM Manual De Instrucciones

Before use

Please read the instructions for use and Important Safeguards
carefully.
Dual voltage
The appliance can work on both, 120V or 230V, AC
systems. Be sure the dual voltage selector is in
the correct voltage position before plugging in.
To do this, switch the selector which is above the
handle to the right position.
This is a 120V dual voltage appliance and may be
used in North America without an electrical
converter. An adapter plug may be necessary
when using appliance in foreign countries.
If needed, plug the steambrush into the correct adapter plug for the
specific country and plug assembly into electrical outlet.
Warning! Never switch selector while unit is plugged in.

Filling with water

• Your steam brush has been designed to operate using untreated tap
water. If your water is very hard (check with your local water authority) it
is possible to mix tap water with distilled water in the following
proportions:
- 50% untreated tap water
- 50% distilled or demineralised water.
• Remove any packaging from the appliance.
• Do not plug in or turn on until assembly is
complete.
• Set the voltage to the correct position.
• Remove the lint pad by pulling it to the bottom.
(depending on model)